STANDARD OR ANGLE MOUNTING INSTRUCTIONS
6. Partially loosen the two set screws in the yoke at
the top of the motor housing (Fig. 6).
7. Remove the downrod pin and downrod clip from
the downrod (Fig. 7).
Downrod Pin
Downrod Clip
8. Thread the wires from the motor housing through
the yoke cover, canopy, and out the top of the
downrod (Fig. 8).
Fig. 6
Fig. 7
Fig. 8
7
Set Screws
Downrod
Clip
Downrod
Pin
Canopy
Yoke
Cover
Downrod
Motor
Housing