Honeywell SUTTON Manual page 8

STANDARD OR ANGLE MOUNTING INSTRUCTIONS
9. Slide the downrod into the yoke of the motor
housing, align the holes, and reinstall the
downrod pin and downrod clip. Then retighten the
two set screws (Fig. 9).
Downrod Pin
Downrod Clip
10. Depending on the length of downrod you use,
you may need to cut the lead wires back to
simplify the wiring. If you decide to cut back
the lead wires, it is suggested that you do so in
the following manner: Take the lead wires and
make sure that you have pulled them all the way
through the top of the downrod and measure 8 in.
of lead wire, and then cut the excess wire off with
wire cutters (not included) (Fig. 10).
11. If you cut back the lead wire in Step 10, strip 1/2
in. of insulation from the end of each wire. Twist
the stripped ends of each strand of wire within
the insulation with pliers (not included) (Fig. 11).
Note: If you did not cut back the lead wires in Step
10, Step 11 is not necessary and you may
proceed to Step 12 instead.
Fig. 9
Downrod
Pin
Set Screw
Fig. 10
Fig. 11
Stripped
Wires
8
Downrod
Downrod
Clip
Cut Wires