Standard Or Angle Mounting Instructions - Honeywell 10288 Manual

STANDARD OR ANGLE MOUNTING INSTRUCTIONS

7. Partially loosen the two set screws in the yoke at
the top of the motor assembly (Fig. 7).
8. Remove the downrod clip and downrod pin from
the downrod (Fig. 8).
Downrod Pin
Downrod Clip
9. Feed the wires from the motor assembly through
the yoke cover, canopy, and out the top of the
downrod (Fig. 9).
Fig. 7
Fig. 8
Fig. 9
7
Set Screws
Downrod
Clip
Downrod
Pin
Downrod
Canopy
Yoke
Cover