Table of Contents
Advertisement
Resetting the Terminal
There are two ways to reset the Dolphin terminal: a soft reset and a hard reset.
Soft Reset (Warm Boot)
A soft reset re-boots the terminal without losing RAM data. You would perform a soft reset 1) when the
terminal fails to respond, 2) after installing software applications that require a reboot, or 3) after making
changes to certain system settings.
1. Press and hold Red
decode and scan LEDs flash for approximately three seconds.
2. When the reset is complete, the
Hard Reset (Cold Boot)
A hard reset erases all of the data and applications stored in RAM memory and launches AutoInstall, which
!
re-initializes the terminal.
Hard resets automatically launch a soft reset as part of the boot process.
1. Press and hold Red
decode and scan LEDs light for approximately three seconds.
2. The terminal re-initializes, which re-installs all programs stored in the \IPSM\Autoinstall folder.
Note: Set the time and date after each hard reset to ensure that the system clock is accurate. Tap the date on the
Today Screen
(see page 2-2) to open the Clock setting and set the time and date.
Dolphin® 7600II Mobile Computer User's
Guide–Preliminary
+ ESC
for approximately 5 seconds. The screen turns white and the
Today Screen
+ TAB
for approximately 5 seconds. The screen turns white and the
Rev (a) 01
5/29/08
(see page 2-2) appears.
3 - 25
Advertisement
Table of Contents
