Resetting The Terminal; Soft Reset (Warm Boot); Hard Reset (Cold Boot); Factory Reset - Honeywell Dolphin 99EXLF User Manual

Resetting the Terminal

There are three types of system resets: a soft reset, a hard reset, or a factory reset. The soft and hard
resets preserve all data stored in the file system. Contact a Honeywell technical support representative
for more information on how to perform a factory reset.

Soft Reset (Warm Boot)

A soft reset re-boots the device and preserves any objects created in RAM. You would perform a soft
reset when:
• the terminal fails to respond.
• after installing some software applications.
• after making changes to certain system settings, such as network cards.
1. Press and hold the CTRL
2. The decode and scan LEDs flash for approximately three seconds as the terminal resets.
3. When the reset is complete, the Home screen displays.

Hard Reset (Cold Boot)

A hard reset re-boots the device and closes any open applications running in RAM at the time of the
reset.
1. Press and hold the CTRL
2. The decode and scan LEDs light for approximately 3 seconds.
3. The terminal re-initializes.

Factory Reset

Contact a Honeywell technical support representative for information on how to perform a factory reset.
For contact information, see

Suspend Mode

The terminal goes into Suspend Mode automatically when the terminal is inactive for a programmed
period of time. You can program this time on the Advance tab of the Power System Setting; see
on page 7-16.
To put the terminal into Suspend Mode manually, press the Power key
To wake the terminal from Suspend Mode, press the Power key
Note: You should always put the terminal in suspend mode before removing the battery door. For information on
removing the battery, see
ENT
A LT
C T R L
+ ENTER
A LT
ESC
C T R L
+ ESC
Technical Assistance
Replacing the Main Battery Pack
keys for approximately 5 seconds.
keys for approximately 5 seconds.
on page 18-1.
or SCAN key
on page 2-4.
Power
and the screen turns off.
SCAN
.
2 - 11