Makita DTR180 Instruction Manual page 9

Remaining battery notification
When the battery voltage drops below the required
level, the tool will stop operating, an error tone will
sound, and the number "4" will appear on the display
panel. The error tone will continue to sound until the
power is turned off.
NOTE: If the ambient temperature is extremely low,
the error tone may sound even when the battery
contains sufficient power.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Loading the tie wire (wire reel)
CAUTION:
Before mounting or dismounting
tie wires and accessories, be sure to turn the
power off, lock the trigger, and remove the battery
cartridge. Failure to do so may cause an accident.
NOTICE:
Using wires other than Makita's genu-
ine tie wires may cause the tool to malfunction.
1. Push the release lever, and lock it with the lock lever.
2
► 1. Release lever 2. Lock lever
When you push the release lever, a gap is created
between the left and right feed gears.
2
► 1. Release lever 2. Lock lever 3. Feed gears
1
1
2. Open the reel cover.
► 1. Reel cover
3. Mount the wire reel on the tool in the orientation
shown in the figure.
► 1. Wire reel
NOTICE:
Be sure to mount the wire reel in the
orientation shown in the figure. If it is mounted the
other way around, the wire will be released and may
be twisted.
4. Unhook the wire tip from the hook of reel.
3
► 1. Hook
9 ENGLISH
1
1
1