Makita DTR180 Instruction Manual page 17

1
► 1. Bolt A 2. Bolt B 3. Contact plate cover 4. Wire guide B
NOTICE:
Do not forcibly remove any bolts that
cannot be removed using the hex wrench.
2.
Pull the contact plate cover up in the direction of the
arrow and remove it. Bolt B will be removed at the same time.
2
1
► 1. Contact plate cover 2. Bolt B
3. Remove bolt A, and remove wire guide B.
1
2
► 1. Bolt A 2. Wire guide B
2
3
4
4. Turn wire guide B over and clean its inside.
5. Remove cutter A, cutter B, top plate, and link arm
A from arm plate A. Then, clean them.
1
5
► 1. Cutter B 2. Link arm A 3. Cutter A 4. Arm plate A
5. Top plate
Assembling
When cleaning is finished, assemble the parts accord-
ing to the following procedure.
1.
Install cutter A and link arm A to fit the shape of
arm plate A.
1
► 1. Cutter A 2. Link arm A 3. Arm plate A
17 ENGLISH
2
3
4
2
3