Makita DTR180 Instruction Manual page 10

5. Make the tip of the wire straight, and pass the wire
through the guide.
► 1. Guide
NOTE: If the tip of the wire is bent when it is passed
through the guide, the wire may become jammed in the tool.
NOTE: If you force the wire when trying to pass it
through the guide, the wire may become jammed.
6.
Pull the wire out approximately 10 mm from the tip of the arm.
► 1. Arm 2. Approximately 10 mm
NOTICE:
If the length of the pulled-out wire is
insufficient, the wire may be broken off when tied,
or tying strength may be compromised due to
insufficient wraps.
7. Rewind the wire to eliminate its slack.
1
2
1
8. Release the lock lever. The release lever returns,
and the wire is held by the left and right gears.
1
2
► 1. Release lever 2. Lock lever
3
► 1. Gear 2. Path of the wire 3. Wire
10 ENGLISH
2
1