Honeywell ScanPal EDA10A User Manual page 48

Trigger Settings
Setting
Enable Scan
Trigger
Scan delay
Decode timeout
Trigger Scan
Mode
Presentation
Mode
Same symbol
timeout
Notification Settings
Use the Notification Settings to configure how your computer responds when you
scan a barcode.
Notification Settings
Setting
Good Read Notification
Bad Read Notification
Vibrate On Notification
38
DRAFT - 3/24/23
Description
Enable or Disable activating the imager by pressing the side scan
buttons or the virtual Scan button in the Scan Demo app.
Set the minimum amount of time in seconds before the scanner
can read another barcode.
Set the number of seconds before the scanner automatically turns
off if the scan button is pressed and nothing has successfully
decoded.
Set read behavior on scan button press. Options available:
• One Shot
• Continuous
• Read on release
• Read on second trigger press
Presentation Mode uses ambient light and scanner illumination to
detect barcodes. When in Presentation Mode, the LEDs remain
dim until a barcode is presented to the scanner, then the aimer
turns on and the LEDs turn up to read the code. If the light level in
the room is not high enough, Presentation Mode may not work
properly.
Set the minimum buffer time in seconds before the scanner reads
the same barcode. This can be adjusted to prevent inadvertent
scans of the same barcode if the code is left in the scan field longer
than the Decode Timeout limit. The default same symbol timeout is
1000 seconds.
Description
Enables or disables a good read notification. The
notification consists of a green blink of the Scan Status
LED, a short beep, and an optional short vibration.
Enables or disables notification of a failed scan. The
notification consists of a red blink of the Scan Status LED,
an error beep, and an optional short vibration.
Enables or disables whether the computer vibrates when
there is a good or bad read.
EDA10A Enterprise Tablet User Guide
Default
Enabled
0
20
One
Shot
Disabled
Disabled
Default
Enabled
Disabled
Disabled