Dell EMC PowerEdge MX7000 Field Service Manual page 56

2. If applicable, Remove the modules from fabric C
3. If applicable, Remove the management
Steps
1. Use a Phillips #2 screwdriver, loosen the captive screws that secure the input and output cage to the enclosure.
2. Use the hand holds located in the Fabric B2 slot to pull the cage partially out of the enclosure until it clicks and locks.
Figure 64. Releasing the input and output cage
3. Press the blue release buttons to release the input and output cage.
NOTE:
● The blue release buttons are on the underside of the cage, and it is indicated by a yellow label on the side of the
cage.
● The yellow labels are visible only when the input output cage is pulled out of the enclosure.
56 Field service information
slot.
modules.