Dell EMC PowerEdge MX7000 Field Service Manual page 48

Removing a module from Fabric A or B slot
Prerequisites
1. Disconnect the cables that are connected to the modules.
Steps
1. Press the orange release button on the module to open the release levers.
2. Hold the release levers, and pull the module out of the enclosure.
NOTE: Ensure that you install an IOM blank if you are removing a module permanently.
Figure 53. Removing a module from Fabric A or B slot
Installing a module in Fabric A or B slot
Steps
1. Align and push the I/O module into the enclosure.
2. Close the release lever to lock the module in place.
48 Field service information