Blower Operation - Makita ADBU05 Instruction Manual

Speed adjusting dial
Fig.9
► 1. Speed adjusting dial
The speed can be changed by turning the speed adjusting dial
to a given number setting from 1 to 3. Higher speed is obtained
when the dial is turned in the direction of number 3. And lower
speed is obtained when it is turned in the direction of number 1.
Refer to the table for the relationship between the num-
ber settings on the dial and the speed.
Number
3
2
1
NOTICE:
When turning the dial, be sure to com-
pletely release the switch trigger. Otherwise, the
machine may be damaged.
OPERATION
CAUTION:
Do not place the machine on the
ground while it is switched on. Sand or dust may
enter from suction inlet and cause a malfunction or
personal injury.

Blower operation

CAUTION:
When performing the blower
operation, be sure to remove the dust bag from
the machine, and attach the nozzle in place for
blowing.
Hold the machine firmly with a hand and perform the
blowing operation by moving it around slowly. When
blowing around building, big stone or vehicle, direct the
nozzle away from them. When performing an operation
in a corner, start from the corner and then move to wide
area.
1
Speed
High
Medium
Low
10 ENGLISH
For XBU05 / ADBU05
Fig.10
For XBU06
Fig.11
Vacuuming operation
CAUTION:
When performing the vacuuming
operation, be sure to attach the dust bag and
nozzle in place to the machine.
CAUTION:
Check the dust bag frequently for
wear or deterioration.
CAUTION:
Be sure to fasten the fastener of
the dust bag before operating the machine.
CAUTION:
Always switch off the machine
before opening or fastening the fastener of the
dust bag.
NOTICE:
When performing the vacuuming oper-
ation, do not use the garden nozzle. The materials
sucked may be clogged, and cause a malfunction of
the machine.
NOTICE:
Do not allow wet materials, such as
wet leaves, and foreign materials, such as large
wood chips, metals, glass, pebbles, etc., to be
sucked into the machine. Otherwise, a malfunction
may occur.
NOTICE:
Empty the dust bag before it becomes
full. Otherwise, a malfunction may occur.