Table of Contents
Advertisement
Available languages
Available languages
Switch action
WARNING:
Before installing the battery car-
tridge into the machine, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released.
► 1. Switch trigger
To start the machine, pull the switch trigger. The speed
is increased by increasing pressure on the switch trig-
ger. Release the switch trigger to stop.
NOTICE:
If the machine has been operated con-
tinuously until the battery has become empty, rest
the machine for at least 15 minutes before operat-
ing the machine with a fresh battery.
Speed adjusting dial
1
► 1. Speed adjusting dial
The speed can be changed by turning the speed adjust-
ing dial to a given number setting from 1 to 3. Higher
speed is obtained when the dial is turned in the direc-
tion of number 3. Lower speed is obtained when it is
turned in the direction of number 1.
Refer to the table for the relationship between the num-
ber settings on the dial and the speed.
Number
3
2
1
NOTICE:
When turning the dial, be sure to com-
pletely release the switch trigger. Otherwise, the
machine may be damaged.
1
OPERATION
CAUTION:
ground while it is switched on. Sand or dust may
enter from suction inlet and cause a malfunction or
personal injury.
Blower operation
CAUTION:
operation, be sure to remove the dust bag from
the machine, and attach the nozzle in place for
blowing.
Hold the machine firmly with a hand and perform the
blowing operation by moving it around slowly. When
blowing around building, big stone or vehicle, direct the
nozzle away from them. When performing an operation
in a corner, start from the corner and then move to wide
area.
For BU01
10 ENGLISH
Speed
High
Medium
Low
Do not place the machine on the
When performing the blower
Advertisement
Table of Contents
