Care, Cleaning & Storage - Breville LAP308 Instruction Book

Care, Cleaning
& Storage
The air purifier and filter should be cleaned at
least once every month. Ensure the air purifier
is switched off and disconnected from the
power outlet and allow all parts to cool before
cleaning or storing.
• Use a clean, dry cloth to clean all external
surfaces of the air purifier.
• Store the air purifier in an upright position.
Do not store anything on top of the air
purifier.
NOTE
More frequent cleaning may be required
depending on environmental conditions.
BREVILLE RECOMMENDS
• Always ensure the air purifier is turned
off, switched off at the power outlet and
unplugged and allow the unit to cool
before performing any cleaning or filter
replacement.
8
DO NOT stick any foreign objects or your
fingers inside the air inlet/outlet of this unit.
8
DO NOT use gasoline, benzine, thinner,
harsh cleaners, etc. on and/or in the unit
while cleaning as they will damage the unit.
8
NEVER use alcohol or other solvents
on this unit.
12
CLEANING THE SENSOR
• It is important to keep the air quality sensor
clean for best performance.
• The air quality sensor is situated behind a
grill at the rear of the unit.
• Gently vacuum the air quality sensor grill
using a small hand brush tool. Cleaning
should occur regularly, at least once a month.
• If more dust can be seen on the sensor
behind the grill then remove the cover by
using the raised tab on the edge of the cover.
Push inwards and outwards simultaneously
to open the cover, noting that it will be tight.
• Gently vacuum the metal shield of the air
quality sensor using the hand brush tool.
• Replace the cover when clean, ensuring it
clicks into place.
WARNING
The air quality sensor is fragile and can be
damaged if excessive force is used during
cleaning. Please use extra care when cleaning.
FILTER CLEANING AND REPLACING
WARNING
The filter is not washable. Do not immerse any
part of the air purifier in water as it will cause
damage.
• The Pre-filter should be cleaned at least once
every month using a vacuum cleaner. Gently
vacuum using a hand-tool attachment such
as a brush or upholstery tool. Clean more
often if required.
• Do not attempt to clean the carbon filter with
a vacuum as this can cause damage.
• Do not use any solutions, hard bristle
brushes or sharp objects to clean as this
can cause damage.
• Replace the filter as indicated using the
instructions following.
REPLACING THE FILTER
Your Smart Air Connect Purifier filter should
TM
be replaced in the time frames indicated below.
• The filter life is approximately 6 months if
used 24 hours daily, or 12 months if used
12 hours daily.
• The filter life may vary to this timing
depending on environmental conditions.
• Remove all packaging from the replacement
filter and place the filter into the unit as
described below.
1. Carefully, turn your air purifier upside down
and remove the locking knob from the base
of the unit.
2. Remove the base plate.
3. Remove the used filter, being careful that
any residue or debris that may fall from the
filter will not cause damage.
4. Insert the replacement filter into the unit,
ensuring that it is correctly fitted and
centred.
5. Replace the base plate and refasten the
locking knob.
6. Return the air purifier to an upright
position.
7. Turn on the air purifier then press and hold
the Microbe Shield /Night Mode/Filter
TM
Reset button for 5 seconds to reset the Filter
Reset light.
NOTE
There is no top or bottom on the filter. The
filter can be placed into the unit either way.
NOTE
If the filter is not in place or not fitted correctly,
the air purifier will not operate.
WARNING
Unintended use of the air purifier or damage
to the housing may result in the escape of
dangerous Microbe Shield UV-C radiation
TM
which is dangerous to the eyes and skin.
Never operate the UV-C light outside of the air
purifier.
UV-C LIGHT CARE
The replacement of the UV-C light must be
undertaken at an authorised Breville service
centre. Please contact Breville Customer
Service Centre for further support.
REPLACEMENT FILTERS
Replacement filters can be purchased from
the Breville website^ or at participating retail
outlets.
See the table below for the replacement
product code to suit this Breville Air Purifier.
Breville Air Purifier Filter Replacement
Model No. Product Code
the Easy Air Connect LAP015WHT
TM
LAP158WHT
LAP030WHT
the Smart Air Connect
TM
LAP308WHT
the Smart Air Plus LAP050WHT
TM
Connect
LAP508WHT
^Delivery charges may apply.
Please contact Breville Customer Service
Centre for further support.
Only use the original Breville filter specially
intended for this appliance. Do not use any
other filters.
13