Advertisement
Care & Cleaning
Before carrying out any maintenance or cleaning of the unit, make sure that the power to the unit
is turned off and power cord is unplugged from the power socket.
EXTERNAL CLEANING OF UNIT
1. Do not clean unit with any abrasive cleaning
agents or solvents.
2. Do not apply any water directly onto
the unit.
3. Only use a soft clean cloth for all cleaning
purposes.
4. Clean the air inlet and outlet with a dry
cloth, soft brush or vacuum cleaner.
CLEANING THE PRE-FILTER
It is recommended that the Pre-filter
(the removable white layer) is cleaned every
2 weeks of unit operation, depending on the
air quality of the room. To clean the Pre-filter:
1. The removable pre-filter is attached by
Velcro. Gently peel away the pre-filter.
2. Run a vacuum cleaner with a nozzle or
brush attachment on low power setting
along both sides of the pre-filter layer.
3. Reattach the pre-filter layer.
CLEANING THE HEPA AND
ACTIVATED CARBON FILTER
It is recommended that the HEPA and
activated carbon filters are cleaned every
100–500 hours of unit operation, depending
on the air quality of the room.
To clean the HEPA and Activated Carbon Filter:
1. Turn off unit and disconnect the power.
2. Place both hands at the bottom corners of
the front cover, and pull out.
3. Pull out the filter by the white belt attached.
4. Gently peel away the Pre-filter layer.
5. Run a vacuum cleaner with a nozzle or
brush attachment on low power setting
along the HEPA (white side) and Activated
Carbon (black side) filters to pick up the
dust and various particles.
10
6. Re-attach the Pre-filter layer and place back
into the air purifier.
NOTE
When placing the filters back into the air purifier,
ensure that the white belts are facing outwards.
REPLACING FILTER
When the lifespan of the 3-layer filter reaches
it end, the POWER light will flash indicating
that it needs to be changed. Discard the old
filter and replace with a new one. It is not
reusable. Cli-Mate Replacement Filter
Product Code: CLI-AP20-RF.
The lifespan and duration of the three
layer filter depends on the air quality and
surrounding environment. The higher level
of pollutants, the shorter the filter lifespan.
It is advisable to change the 3-layer filter
at least every 8 months or 2000 hours
of unit operation.
HOW TO REPLACE THE FILTER
1. Turn off unit and disconnect the power.
2. OPEN THE FRONT COVER: Place both
hands at the bottom corner of the front
cover, press down the buttons on the sides
while pulling out.
3. REMOVE THE FILTER: Pull out the filter
by the white belt attached and discard.
4. INSTALL NEW FILTER: Replace with
new filter. Ensure that the white belt
is facing outwards.
5. Line up the top of the front cover first and
then snap in the lower part of the front cover.
Ensure that the front cover is firmly intact.
6. Hold down Speed
to reset the filter timer.
button on the unit
Advertisement
