Digicom 3G Industrial Router VPN Pro Quick Manual page 22

3G Industrial Router VPN Pro
eth0@ethernet
IteM
IP Address, Netmask, MtU @ LAN Interface Set the IP address, Netmask and MTU of Eth0. These parameters will be un-
Multiple IP Address @ LAN Interface Assign multiple IP addresses for Eth0.
enable DHcP server @ DHcP server Enable to make router can lease IP address to DHCP clients which connect to Eth0.
IP Pool start, IP Pool end @ DHcP server Define the beginning (IP Pool Start) and end (IP Pool End) of the pool of IP addresses
Netmask @ DHcP server Define the Netmask which the DHCP clients will obtain from DHCP server.
Lease time @ DHcP server(min) Define the time which the client can use the IP address which obtained from DHCP server.
Primary/secondary DNs server @ DHcP server Define the primary/secondary DNS Server which the DHCP clients will obtain
Windows Name server @ DHcP server Define the WINS Server which the DHCP clients will obtain from DHCP server.
static Lease @ DHcP server Define to lease static IP Addresses, which conform to MAC Address of the connected equipment.
Router can be DHCP Relay, which will provide a relay tunnel to solve problem that DHCP Client and DHCP Server is not in a same
subnet. This section allow user to configure DHCP Relay settings.
DhcP relay @ ethernet
IteM
DHcP server
3.10
DescRIPtIoN
configurable if you enable Bridge.
Default: Null
Default: Null
Default: enable
which will lease to DHCP clients.
Default: 192.168.0.2 / 192.168.0.100
Default: 255.255.255.0
Default: 60
from DHCP server.
Default: 192.168.0.1 / 0.0.0.0
Default: 192.168.0.1
Default: Null
DescRIPtIoN
Enter DHCP Server's IP address.
Note: Please disable DHCP Server and DHCP Client first to make sure DHCP relay can be enabled.
Default: Null
Configuration settings over web browser