Honeywell Middle East
Emaar business Park,
UAE
PS-HL-138xxBM Series : 13.8V dc Switch Mode Power Supplies
with Standby battery charging, fault monitoring & remote fault signalling
PS-HL-13805BM-4OP (5A / 4 x Fused Outputs)
F
EATURES
High efficiency cost effective power supply range ideal for Access Control applications.
Featuring a regulated 13.8V dc output supplying continuous full rated current to load
and a universal mains voltage input. Standby battery recharging is achieved within 24h
for an 18Ah battery. Maximum battery life is assured using deep discharge protection
to prevent premature battery failure when operating in standby mode for extended
periods. Two sets of volt free contacts are provided to signal (i) loss of mains and (ii)
battery and loss of output faults. The 5A model is provided with 4 x 1.25A Fused
Outputs whilst the 10A model is provided with 8 x 1.25A Fused Outputs.
•
Continuous full rated current to load
•
18Ah Standby battery recharged to 80% within 24 hours
•
Universal mains input voltage 90-264V ac
•
High efficiency electronics for reduced running costs and lower operating
temperatures
•
Installer safe design with all high voltage electronics fully shrouded
•
Full electronic short circuit and overload protection on load output under mains
operation
•
Mains transient protection circuit
•
Lid and removal from wall tamper detection
•
Green Mains present LED
•
Red Fault LED
•
Volt free contact signalling mains failure
•
Volt free contact signalling output and battery faults
•
Individually Fused Outputs
Tel:
:
www.honeywell.com
PS-HL-13810BM-8OP (10A / 8 x Fused Outputs)
PAK200467-HW_01A March 2020
+971 4 450 5800
1
2020 Honeywell Security