Lubricating Moving Parts - Makita BR400MP Original Instruction Manual

Overall inspection
• Tighten loose bolts, nuts and screws.
• Check for damaged parts, brushes, or sweep
drums. Ask our authorized service center to
replace them if necessary.
Inspecting the brushes, sweep
drums, and protector
Check and clean the brushes, sweep drums, and pro-
tector daily. If they are worn, bent and cracked, replace
them.
Replacing the brushes or sweep
drums
1. Remove the clips from the brushes or sweep
drums, and then remove the brushes or sweep drums.
► 1 . Brush 2. Clip
2. Attach the brushes or sweep drums to the brush
unit or sweep drum unit, and then attach the clips.
NOTICE:
sure to attach them with the Makita logo facing
outside.
NOTICE:
sure to attach them in the direction shown in the
figure, so that the sweep drums and the gear case
mesh with each other.
1
1
► 1 . Sweep drum 2. Gear case

Lubricating moving parts

NOTICE:
2
quency and amount of grease supplied. Otherwise
insufficient lubrication may damage moving parts.
Gear case:
CAUTION:
gear case is hot. Hot gear case can cause burn
injury.
Fill approx. 30 ml of grease (Makita grease SG No.0)
through the grease port evenly every 25 hours of
operation.
With the supplied hexalobular wrench, remove the bolt
near the lubrication marking on the gear case. Loosen
the bolt on the other side so that the air in the gear case
can be released when applying the grease.
After applying the grease, be sure to tighten the bolts.
11 ENGLISH
When attaching the brushes, be
When attaching the sweep drums, be
2
Follow the instruction of the fre-
Do not apply grease when the