Case Tamper Switch Installation; Power Up; Enrolling The Module - GE NX-592E-GSM Installation Manual

Case tamper switch installation

If your module is easily accessible, you should consider adding a case tamper detection switch. When the
module cover is removed, this switch activates an alarm or trouble signal (depending on panel programming).
To install the case tamper switch, see Figure 5 and do the following:
1. Slide the reed switch into the plastic holder on the module backplate.
Figure 5. Installing a case tamper switch
Module backplate
To zone input
2. Connect a reed switch (with EOL resistor) to any unused hardwire input on the panel. For the EOL
resistor value, see the control panel installation manual.
3. Press the magnet into the tabs located on the module cover. Next, press the magnet clip over the
magnet until the clip locks into place.

Power up

To power up the module, do the following:
1. Verify that all wiring between the panel and module are correct.
2. Reconnect the backup battery and restore panel AC power.

Enrolling the module

The NetworX control panels automatically find and store in memory the presence of all keypads, zone
expanders, wireless receivers, output modules, and any other device on the keypad bus, allowing these devices
to be supervised by the control panel. To enroll the devices, enter Program Mode (refer to your control panel
documentation). When you exit Program Mode, the control panel automatically enrolls the devices. This
process takes about 12 seconds. During this time, the Service LED will illuminate and User codes will not be
accepted. Once a module is enrolled, if it is not detected by the control, the Service LED will illuminate. When
initially powering up, the control panel automatically performs the device enrollment process.
Magnet
Magnet clip
EOL resistor
Module cover
9