Table of Contents
Advertisement
Turning On Power
2.
Hold down the sensor unit button for about two seconds.
Holding down the button will cause the sensor unit to beep twice. Next, the
sensor unit's LED will light either green or orange. Release the button at this
time. Release the button at this time. This turns on power.
• If the LED lights red for about two seconds, it means that remaining battery
power is low. Charge the sensor unit. Use the Runmetrix app to check the
remaining battery charge.
Receiving GPS Signals
3.
To receive GPS signals, you should be outdoors in a location
where the sky is visible and not blocked by buildings, trees, or
other objects. Stop moving and hold the sensor unit with its
clip side facing upwards. The sensor unit LED will light green
when signal reception is complete.
YES
• The receive operation may take longer if you try to receive GPS signals
while in motion.
• You can check the status of GPS reception by checking the sensor unit's
LED.
Lit orange: Receiving
Lit green: Reception complete
• You can shorten the time required for GPS reception by sending GPS
assist data to the sensor unit from the Runmetrix app in advance. For
details about how to do this, visit the CASIO website.
✹
IMPORTANT!
• The sensor unit stores location information in its memory. To protect your data,
take care not to lose the sensor unit.
NOTE
• Under some reception conditions, it may take several minutes to receive GPS
signals.
• Atmospheric conditions and your usage environment can affect location
measurement.
• The following conditions can reduce the accuracy of GPS measurements or
make measurement impossible.
– Indoors or in other locations where the sky is not visible
– Near equipment that emits strong radio waves
– The following locations, where signals are being blocked: near trees or
buildings, in crowds
• Measurement can be started even if GPS signals cannot be received for some
reason. In such a case, certain reception environments may result in location
information not being recorded or large error.
• This sensor unit is compatible with GPS (United States), QZSS (Japan), and
GLONASS (Russia). In this manual, "GPS" refers to all supported positioning
systems.
Starting Measurement
4.
Press the sensor unit button once.
Release the button when you hear a beep. The LED will flash green or
orange, and measurement will start.
• Be sure to check for flashing of the LED before mounting.
5.
Slide the clip slide lock upwards to
unlock it.
NO
Slide lock
7
Advertisement
Table of Contents
