Table of Contents
Advertisement
5.
Hold down the sensor unit button for about five seconds, and
then release it.
Holding down the button will cause the sensor unit to beep twice as power
turns on. Keep the button depressed until the sensor unit's LED flashes
between orange and green. Release the button once the flashing starts. Note
that if you keep the button depressed too long after the flashing starts, the
sensor unit will beep again and the LED will flash between orange and green
at high speed. This is the watch pairing mode. If you enter the watch pairing
mode by mistake, release the sensor unit button and then hold it down again
to turn off power. Next, perform step 5 again.
Pairing with a Watch
• Only one watch at a time can be connected with this sensor unit.
• Pairing the sensor unit with a compatible watch makes it possible to use
the watch to perform sensor unit operations and monitor measurements in
real-time.
To pair the sensor unit with a watch
1. Put the watch into its sensor pairing mode.
2. Hold down the button of the sensor unit for about seven seconds to
enter its pairing mode.
• Holding down the button of the sensor unit will cause the sensor unit
to beep twice as power turns on.
3. Keep the button depressed, and the sensor unit's LED will start to flash
between orange and green.
4. Keep the button depressed until the sensor unit beeps again and the
LED flashes between orange and green at high speed.
5. Release the button.
• For more information on pairing with your watch, see your watch's
user's guide.
6.
In the Runmetrix app, tap "Start registration".
When the registration of the sensor unit is complete and the sensor unit is
Bluetooth paired with a phone, the top Runmetrix screen will appear on the
phone.
• Turning off the sensor unit will terminate its connection with your phone.
5
Advertisement
Table of Contents
