Advertisement
3.2 PMB-AUX
The PMB-AUX Power supply comes pre-installed on a chassis for easy installation in a CAB-5 series cabinet.
1.
Mount the chassis to the backbox by aligning the two mounting tabs with the slots in the backbox, then position the two mounting hole tabs over
the studs with nuts located in the upper portion of the backbox.
2.
Slide the tabs located on the bottom of the chassis into the mounting slots in the backbox by pressing the chassis down.
3.
Secure the chassis to the backbox. Fasten the two supplied #8 keps nuts over the mounting holes at the top.
PMB-AUX(-RTO) Power Supplies— P/N LS10242-000GE-E:B 5/4/2022
mounting holes
mounting tabs
Figure 2 PMB-AUX Installation
mounting studs
mounting slots
ground studs
3
Advertisement
