Installing Table - Grizzly G0512 Owner's Manual

Installing Table

Before installing the table, the sanding belt must
be tracking correctly to ensure that the idler roller
is close to the position that it will be in during
operation. Do not perform the following steps until
after the Test Run is complete.
To install table:
1.
DISCONNECT MACHINE FROM POWER!
2.
Attach leadscrew bracket assembly to stand
with (4) pre-installed hex bolts and washers
shown in Figure 22.
x 4
Leadscrew
Bracket
Assembly
Figure 22. Leadscrew bracket assembly
attached to stand.
3. Identify which L-bracket is which before
continuing (see Figure 23).
Adjustment
L-Bracket
Motor
L-Bracket
Figure 23. L-bracket identification.
Model G0512 (Mfd. Since 12/22)
4.
L-Bracket
5.
L-Bracket
6.
7.
Idler
L-Bracket
Attach motor L-bracket to rear of stand on side
closest to motor with table lock handle and (2)
⁄ " flat washers, as shown in Figure 24.
3
8
Motor
Motor
Figure 24. Motor L-bracket installed.
Repeat Step 4 with idler L-bracket at rear left
of machine, as shown in Figure 25.
Idler
Figure 25. Idler L-bracket installed.
Repeat Step 4 with adjustment L-bracket at
remaining location on front right of machine.
Loosen all (4) table lock handles, use table
height handwheel to lower leadscrew table
bracket all the way down (see Figure 26),
then adjust L-brackets as far down as they
will go.
-21-