Installing Work Table - Grizzly G1140 Owner's Manual

installing Work table

to install the work table:
1.
disConneCt sander FroM poWer!
2. attach the leadscrew bracket to the front of
the stand using the four preinstalled
1" hex bolts and lock washers, then install the
lock handle with the thin
figure 12. leadscrew bracket installed.
3. thread a / "-13 hex nut
1
2
the horizontal brace, and thread a
/ " hex bolt into the shaft on the horizontal
1
2
brace (figure 13), making sure the bolt end
is flush with the inside of the shaft.
horizontal Brace
⁄ "-18 x
5
16
hex Bolt
figure 13. horizontal brace installed.
4. thread the horizontal brace into the sander
(figure 13), but do not tighten the hex nut
yet; the brace will require further adjustment
later.
-20-
/ "-16 x
3
8
/ " flat washer.
3
8
4x
lock
handle
⁄ of the way onto
3
4
/ "-18 x
5
16
⁄ "-13
1
2
hex nut
⁄ "
1
2
5.
rotate the handwheel so it is in the center
of the leadscrew, then insert the leadscrew
assembly into the leadscrew bracket, as
shown in figure 14. position the leadscrew
assembly so the red pointer is on the left
side.
leadscrew
figure 14. leadscrew assembly installed.
6.
turn the horizontal brace approximately 45˚.
7.
install a / "-13 hex nut and flat washer onto
1
2
the vertical brace until 1" of the threaded end
is visible above the washer.
8. insert the vertical brace through the shaft
at the end of the horizontal brace (figure
15), then rotate the horizontal/vertical brace
assembly to 90˚. do not tighten the fasteners
yet.
table
Bracket
figure 15. horizontal/vertical brace installed.
9.
insert the threaded end of the vertical brace
through the hole in the bottom of the table
bracket (figure 15) and install a
hex nut and flat washer onto the shaft end
(figure 16). thread the handwheel down
until it touches the top of the leadscrew
bracket.
g1140/g1531 6" X 80" edge sander
handwheel
Vertical
Brace
⁄ "-13
1
2