Setting Outfeed Table Height - Grizzly G0634X Owner's Manual

Place identical 2" C-clamps on each pulley
3.
with adjustment shafts facing out. Place
straightedge on clamps, as shown in Figure
54, and visually check pulley alignment.
C-Clamp On
Pulleys With
Adjustment
Shafts Facing
Out (1 of 2)
Figure 54. Example of checking belt alignment.
— If pulleys are aligned, then no adjustments
are necessary.
— If pulleys are NOT aligned, perform Steps
3–4.
4. Remove V-belts (see Page 42).
5. Loosen set screws on end of cutterhead pul-
ley, align cutterhead pulley with motor pulley
(see Figure 55), then retighten set screws.
Cutterhead
Motor
Alignment
Figure 55. Pulleys properly aligned.
6. Repeat Step 2 and, if necessary, repeat
Step 4 until pulleys are aligned.
7. Reinstall all components removed during
Step 1.
-44-
Set Screws
Cutterhead
Pulley
Motor
Pulley
Setting Outfeed
Table Height
The outfeed table height MUST be level with the
carbide inserts when they are at top-dead-center.
If the outfeed table is set too low, the workpiece
will be tapered from front to back. If the outfeed
table is set too high, the workpiece will hit
the edge of the outfeed table during operation,
increasing the chance of kickback.
To set outfeed table height:
DISCONNECT MACHINE FROM POWER!
1.
Place straightedge on outfeed table so it
2.
extends over cutterhead.
Open motor access panel and rotate
3.
cutterhead pulley until one of carbide inserts
is at top-dead-center (TDC), as illustrated in
Figure 56.
Top Dead
Center
Figure 56. Carbide insert at top-dead-center.
4. Raise or lower outfeed table until carbide insert
just touches straightedge (see Figure 57).
Straightedge
Bottom Dead
Center
Outfeed
Figure 57. Using straightedge to align outfeed
table height with carbide insert at TDC.
Model G0634X (Mfd. Since 11/20)
Infeed