Makita DUH501 Instruction Manual page 9

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
When replacing the shear blades,
always wear gloves so that your hands do not
directly contact the blades.
NOTICE:
When replacing the shear blades, do
not wipe off grease from the gear and crank.
Installing or removing the shear
blades
CAUTION:
Attach the blade cover before
removing or installing the shear blades.
You can install 500 mm (19-3/4"), 600 mm (23-5/8"), or
750 mm (29-1/2") shear blades to your tool.
1. Place the tool upside down, and then remove 6 bolts.
► 1. Bolt
2.
Remove the cover and the plate.
► 1. Cover 2. Plate
NOTE: The plate may remain on the cover.
3. Remove the rod.
► 1. Rod
NOTE: The rod may remain on the cover.
4. Remove 2 screws, the felt pad and the sleeves,
and then remove the shear blades.
1
► 1. Felt pad 2. Screw 3. Sleeve 4. Shear blades
5.
Remove the blade cover, and then attach it to the
1
new shear blades.
6. Adjust the crank so that 2 holes are lined up on
the alignment line.
2
2
► 1. Hole 2. Alignment line
9 ENGLISH
1
2
3
1
4
1