Verifying Power - NETGEAR PS104 Installation And Reference Manual

Verifying Power

To complete the installation, connect the power adapter first to the power adapter receptacle on the
print server rear panel and then to the power outlet on the wall. When power has been applied to
the print server:
• The green PWR (power) LED on the front panel is on.
• On the Model PS104 Print Server and the Model PS105 Print Server, the green Link/Rx LED
on each connected network port is on.
• On the Model PS110 Print Server, the green Link LED on each connected printer port is on.
• The green Link/Act LED on the connected PRINTER, PRINTER 1, or PRINTER 2 port is on.
Make sure the network interface cards installed in the workstations are in working condition and
the software driver has been installed on the cards.
If required, verify the integrity of the print server by resetting it. Turn power to the print server off
and then back on. If the problem continues and you have completed all the preceding diagnoses,
contact NETGEAR Customer Support. For the telephone number of the representative in your
area, refer to "Customer
Installation
Installation and Reference for the Model PS104/PS105/PS110 Print Server
Support" on page iii.
2-3