Verify Power - NETGEAR PS 104 Quick Installation Manual

4

Verify Power

Connect the power adapter first to the power receptacle on the rear panel of the print server and
then to the power outlet on the wall. When power has been applied to the print server:
• The green Pwr (power) LED on the front panel is on.
• On the Model PS104 Print Server, the green Link/Rx LED on each connected network port
is on.
• On the Model PS110 Print Server, the Link LED on the connected network port is on.
• The green Link/Act LED on the connected PRINTER, PRINTER 1, or PRINTER 2 port
is on.
If there are any problems, refer to "Troubleshooting Information."
Make sure the network interface cards installed in the workstations are in working condition and
the software driver has been installed on the cards.
If required, verify the integrity of the print server by resetting it. Turn power to the print server off
and then back on. If the problem continues and you have completed all the preceding diagnoses,
contact NETGEAR Customer Support. For the telephone number of the representative in your
area, see "Customer Support" on the back cover of this installation guide.
Model PS104 and Model PS110 Print Server Quick Installation Guide