NETGEAR WGR101 Reference Manual page 43

Figure 4-4: Wireless Card Access List Setup
Click the Turn Access Control On check box.
4.
Click Add to add a wireless device to the wireless access control list. The Available Wireless
5.
Cards list displays.
Then, either select from the list of available wireless cards the WGR101 has found in your
6.
area, or enter the MAC address and device name for a device you plan to use. You can usually
find the MAC address printed on the wireless adapter.
Note: You can copy and paste the MAC addresses from the Attached Devices menu into the
MAC Address box of this menu. To do this, configure each wireless computer to obtain a
wireless link to the WGR101. The computer should then appear in the Attached Devices
menu.
Click Add to add this wireless device to the Wireless Card Access List. The screen changes
7.
back to the list screen. Repeat these steps for each additional device you wish to add to the list.
Be sure to click Apply to save your wireless access control list settings.
8.
Now, only devices on this list will be allowed to wirelessly connect to the WGR101.
Wireless Configuration
Reference Manual for the 54 Mbps Wireless Travel Router WGR101
February 2005 (202-10034-03)
4-11