How To Log In To The Wireless Travel Router - NETGEAR WGR101 Reference Manual

How to Log in to the Wireless Travel Router

You can always connect to the router to change its settings. The switch settings enable these kinds
of access:
• Switch position 1: single wireless computer only access, no configuration access.
• Switch position 2: configuration and multiple wireless computer access as explained in
"Network Configuration" on page
• Switch position 3: configuration only via Ethernet or wirelessly connected computer as
explained in "Basic Wireless Security WEP Configuration" on page 3-8
• Switch position 4: unused.
Follow these procedures to log in to the wireless travel router.
Figure 3-4: Switch position 3
Set the switch to position 3.
1.
Connect the power cord to the wireless travel router and plug it into an outlet.
2.
Warning: Be sure to power on the wireless travel router before connecting the cable from the
computer. If you do not observe this sequence, your computer may time out and fail to
connect.
Connecting the Router to the Internet
Reference Manual for the 54 Mbps Wireless Travel Router WGR101
6-1.
February 2005 (202-10034-03)
below.
3-5