Messages - Casio KL-1500 Service Manual And Parts List

MESSAGES

Message
NO DATA!
NOT ENOUGH
MEMORY!
NOW PRINTING
NOW PRINTING CUT
THEN [SET]!
SAME NAME
ALREADY USED!
TEXT DOES NOT FIT!
TOO MANY LINES!
TOO MANY LINES
TO FRAME!
WHERE?
CANNOT COMBINE!
CANNOT USE 6 mm
CLEARS INPUT TEXT! The operation you have selected will clear
DATA ERROR!
RESET!
INITIAL?
INPUT TEXT!
LOW BATTERY
MEMORY FULL!
Meaning
There is no data stored in memory.
There is not enough unused memory to
perform the operation.
Printer is performing printing operation.
Printing is paused for a tape cut
operation.
The name you are using when storing
data in memory is already used.
Text is too long to fit in the specified tape
length.
Text has too many lines to fit on tape.
Text has too many lines to fit into a frame. Reduce the number of lines.
Unit is asking for the starting point of the
operation you are performing.
Previously input text cannot be combined
with new input text.
Current operation cannot be performed
using 6 mm tape.
the text you previously input.
Memory data has become corrupted for
some reason.
Memory initialization is required.
Unit is requesting input of text.
Battery power is low.
Memory is full and data cannot be stored. Delete data you no longer need and
Store some data before trying to perform
this operation.
Reduce the size of the data you are
trying to store or delete data already
stored to make room for the new data.
Wait for printing operation to end.
Cut the tape and then press SET to
resume printing.
Use a different name or delete the data
in memory this is under the same name.
Reduce the size of the characters or
shorten the text.
Reduce the number of lines.
Use and
starting point and press SET to specify it.
Perform the operation and input new
text.
Change to a different tape size.
Proceed with the operation (and clear
the text), or press ESC to abort without
clearing anything.
Reset the unit. Note that the reset
operation deletes all data in memory.
Initialize memory.
Input the text you want to print.
Replace batteries or use AC adaptor.
make room for new data.
Table-5
— 10 —
Action
to move the cursor to the