Dotcode Message Length; Digimarc Barcode; Digimarc Decoder Attempts - Honeywell HF52X User Manual

DotCode Message Length

Scan the bar codes below to change the message length. Refer to
Description
lengths = 1-2400. Minimum Default = 1, Maximum Default = 2400.
Minimum Message Length

Digimarc Barcode™

Digimarc Decoder Attempts

Set the number of attempts by scanning the bar code below, then setting the num-
ber of attempts (0-10) by scanning digits from the
on page 223 of this manual, the Save. Minimum to Maximum attempts = 0-10.
Default = 3.
Digimarc Barcode
This setting programs the scanner to decode Digimarc Barcode using Digimarc
and ID decoders. When Digimarc Barcode is set to On, the Digimarc decoder is
used on most frames and the Honeywell decoder will read every fifth frame.
When Digimarc Barcode is set to Use Honeywell Decoder then Both Decoders,
the Honeywell decoder will read the number of attempts set by the Digimarc
Decoder Attempts and then will use both Honeywell and Digimarc decoders. When
Digimarc Barcode is set to Use Digimarc Decoder then Both Decoders, the Digi-
marc decoder will read the number of attempts set by the Digimarc Decoder
Attempts and then will use both Honeywell and Digimarc decoders.
When Digimarc Barcdoe is set to Use Honeywell Decoder then Alternates Decod-
ers, the Honeywell decoder will read the number of attempts set by the Digimarc
Decoder Attempts and then will alternate between Honeywell and Digimarc decod-
ers. When Digimarc Barcode is set to Uses Digimarc Decoder then Alternates
Decoders, the Digimarc decoder will read the number of attempts set by the Digi-
marc Decoder Attempts and then will alternate between Honeywell and Digimarc
decoders.
136
(page 80) for additional information. Minimum and Maximum
Digimarc Decoder Attempts
Programming Chart
HF52X Fix Mount Barcode Scanner User Guide
Message Length
Maximum Message Length
beginning