03 CHAIN BRAKE
10
9
Removing the hand guard and
disengagement mechanism
Remove the starter. See Chap. 06.
Unscrew the handguard screw on the fan
side.
Remove the circlip 6.
Lift the spacer plate 7 over the pin 8, push it
back a little, and remove it from pin 9.
Remove the bushing from pin 8 and 9.
Pull the disengagement mechanism off the
shafts in parallel.
Remove the muffler. See Chap. 04.
Disengage the fan-side handguard arm
towards the muffler.
Reparaturanleitung PS-4600 / PS-5000
Repair Manual PS-32
Pull the handguard off pin 8 using light back-
7
8
6
and-forth motions.
Note: When reassembling, always use a new
circlip 6 (927.304.000)!
Install the handguard in the reverse order.
Make sure that the handguard guide 10 is not
unhooked. If necessary, push it back into
position with a screwdriver (about 4 mm from
pin 9). The handguard can only be assembled
when the rest piece is in this position.
Assemble the disengagement mechanism,
brake band, and brake band spring in the
reverse order.
10
ca. 4 mm
11