Battery Protection System - Makita ADML815 Instruction Manual

Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
► 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
1
2
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
Lighting up the light
CAUTION:
Do not look in the light or see the
source of light directly.
Push the power button to light up the light. To turn off
the light, push the power button again.
1
► 1. Power button

Battery protection system

The tool is equipped with the protection system, which
automatically cuts off the output power for long ser-
vice life. The light goes off during operation when the
remaining battery capacity gets low. This is caused by
the activation of the protection system and does not
show trouble. Remove the battery cartridge from the
tool and charge it.
Head angle
CAUTION:
When changing the head angle,
be careful not to pinch your fingers between the
head and the tool body.
The head angle can be adjusted in 12 stages.
5 ENGLISH