3. Connect the Splitter's built-in Ethernet network cable to the Ethernet port of your remotely located access
point or other network device.
4. Connect the Splitter's Power cord to the Power port of your remotely located access point or other network
device.
NOTE: If the plug of the Splitter's Power cord does not fit into your network device, then use
the included barrel jack adapter. Plug the Splitter's Power cord into the jack end, and plug the
other end of the barrel jack adapter into the Power port of your network device.
5. Connect the Kit's power adapter to the Injector, and plug the other end into an electrical outlet or surge
protector.
Congratulations! The installation of the Power Over Ethernet Kit is complete.
Chapter 3: Connecting the 12 Volt Power Over Ethernet Adapter Kit
Powering on a Device that Uses a Standard Power Adapter
12 Volt Power Over Ethernet Adapter Kit
Figure 3-4: Barrel Jack Adapter (optional)
Figure 3-5: Connect Power to the Injector
11