Powering On A Device That Uses A Standard Power Adapter; Figure 3-2: Connect The Ethernet Cable To The Injector; Figure 3-3: Connect The Ethernet Cable To The Splitter - Linksys WAPPOE12 User Manual

12 Volt Power Over Ethernet Adapter Kit

Powering on a Device that Uses a Standard Power Adapter

To use the Power Over Ethernet Kit, follow these instructions:
1. Connect the Injector's built-in Ethernet network cable to your router, switch, or other network device.
2. Connect the Kit's included Ethernet network cable to the Injector's Power & Data OUT port.
Then connect the other end to the Splitter's Power & Data IN port.
NOTE: If this cable is not long enough, then you can use your own Ethernet network cable.
Figure 3-2: Connect the Ethernet Cable
to the Injector
Figure 3-3: Connect the Ethernet Cable to
the Splitter
10
Chapter 3: Connecting the 12 Volt Power Over Ethernet Adapter Kit
Powering on a Device that Uses a Standard Power Adapter