Chapter 2: Getting To Know The Phone Adapter; Back Panel Ports And Leds; Figure 2-1: Back Panel - Linksys SPA2002 User Manual

Analog Telephone Adapter with 2 FXS Ports

Chapter 2: Getting to Know the Phone Adapter

Back Panel Ports and LEDs

The Phone Adapter's ports and LEDs are located on the back panel.

Figure 2-1: Back Panel

PHONE 1 Port The PHONE 1 port (for your primary Internet phone line) allows you to connect your telephone
to the Phone Adapter using an RJ-11 telephone cable (not included).
PHONE 2 Port If you have a second Internet phone service account, use the PHONE 2 port to connect a
second telephone (or fax machine) to the Phone Adapter using an RJ-11 telephone cable (not
included).
NOTE: The Phone ports do not carry any voltage.
ETHERNET Port The ETHERNET port allows you to connect the Phone Adapter to your router or gateway using
a Category 5 (or better) Ethernet network cable.
POWER Port The POWER port is where you connect the included power adapter.
STATUS LED The STATUS LED remains solid green when the Phone Adapter is powered on and ready. It
flashes green when the Phone Adapter is booting up, undergoing a self-test, or performing
a firmware upgrade.
ACT LED The ACT LED remains solid yellow when the Phone Adapter is connected to your network
through the Ethernet port. It flashes yellow when data is being sent or received through the
Ethernet port.
Chapter 2: Getting to Know the Phone Adapter
Back Panel Ports and LEDs
3