Page 2
Configuration 1. Ensure firmware is at least 5.1.10. 2. Connect your PC to the Linksys SPA2102 on the Ethernet port. 3. Set your PC to get an IP address from the DHCP server(If DHCP is turned off on the Linksys, use 192.168.0.5 and subnet 255.255.255.0) 4. Open the Internet Explorer and type http://192.168.0.1 and Enter. 5. Now you can see the Linksys configuration. 6. Click Admin Login and select Advanced. 7. On the Router setup select WAN setup and select the connection type. (If DHCP is not available type the IP address manually) type the DNS address Pri ‐ 83.137.182.72 and Sec ‐ 83.137.182.73 and click submit all changes. 8. On the Voice setup select Line 1 and change the following settings 8.1. Under Network Settings Network Jitter Level: very high Jitter Buffer Adjustment: disable 8.2. Under Proxy and Registration Proxy: as.vanillaip.com Outbound Proxy: 83.137.182.120 Use Outbound Proxy: yes Register: yes Register Expires: 60 8.3.
Page 3
Auth ID: type user details 8.4. Under Supplementary Service Subscription Call Waiting Serv: no Three Way Conf Serv: no 8.5. Under Audio Configuration Preferred Codec: G711u Use Pref Codec Only: yes Silence Supp Enable: no Echo Canc Enable: no Change “fax enable = T38” to No 9. Click Submit All Changes to save all. Regency 5000 ‐ Linksys SPA2101 Phone Adapter Configuration Guide.Docx V1.00.0001 3 ...