Programmable Options - Linksys SPA962 Quick Installation

2
Connecting a Second SPA932
A maximum of two (2) SPA932 Attendant Consoles can be connected to a SPA962.
The instructions below are for connecting a second SPA932. If you are not attaching a
second SPA932, skip to section 3.
A
Align the hole in the first SPA932 alignment recess with the hole
on the attachment arm.
B
Using the attachment arm screw, secure the attachment arm to
the first SPA932.
B
C
Align the hole in the second SPA932 alignment recess with the
hole on the attachment arm.
D
Using the attachment arm screw, secure the attachment arm to
the second SPA932.
IMPORTANT: Do not plug a telephone line cord into an AUX port. Use only
the auxiliary cable provided with the SPA932.
E
Locate the AUX OUT port on the back of the first SPA932. Con-
nect one end of the auxiliary cable to this port.
F
Locate the AUX IN port on the back of the second SPA932.
Connect the other end of the auxiliary cable to this port.
F
G
Route the auxiliary cable inside the cable relief channel.
H
Attach the approriate desktop stands to each unit. The
SPA932 is powered via the auxiliary cable with the SPA962. No
additional power source is required.
3

Programmable Options

To program the SPA932 Attendant
For product compliance information
Console, refer to the Attendant refer to the SPA IP Phone User Guide,
Console Configuration page in the
available on
SPA962 phone menu. For detailed
http://www.linksys.com/
information regarding these
features, refer to the SPA900 Series
Administration Guide.
For additional information or troubleshooting
help, contact your Service Provider.
Website
Inside the United States:
http://www.linksys.com
Outside the United States:
http://www.linksys.com/international
Linksys is a registered trademark or trademark of
Cisco Systems, Inc. and/or its affiliates in the U.S.
and certain other countries. Copyright © 2007
Cisco Systems, Inc. All rights reserved.
SPA932-QI-70424NC DF