Wiring Diagram - Makita DS4012 Technical Information

W
iring diagram
Fig. D-2
Motor housing
Field lead wires must be
tight in Motor housing.
Line filter
When Line filter is used, pass Field lead wires (orange, purple) through the hole and wind them around
as shown below. Then, connect Lead wire (orange) to Terminal No.3 of Switch, and Lead wire (purple)
to Terminal No. 4 of Switch. (See Fig. D-1 of page 10.)
Wiring of Field lead wires
Line filter
Field
Pass Field lead wires through this hole
to Handle section.
Note: Be careful not to scratch or
damage them by the edges.
Hole
Handle section
to terminal No. 4
to terminal No. 3
P 11/ 12