Makita CC300D Technical Information page 3

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Base
DISASSEMBLING
(1) The machine is fixed to Base assembly with M5x10 Thumb screw at the rear side, and with M5 (+) Pan head screw
and M5-8 Hex nut at the front side. Separate the machine from Base assembly. (Fig. 2)
Fig. 2
Flat Depth guide
washer 5
M5x10 Thumb screw
Unscrew M5x10 Thumb screw
from Depth guide.
Note: Be careful not to lose Spring
washer 5 and Flat washer 5.
(2) Remove Angular guide and Depth guide. (Fig. 3)
Base can be now replaced with new one.
Fig. 3
Depth guide
Disassemble the hinge
portion by removing
Stop ring E-3 and Pin 4.
ASSEMBLING
(1) Fix Depth guide to Base with Pin 4 through Depth guide and Base
from the external side. Secure them with Stop ring E-3. (Fig. 4)
(2) Fix Angular guide to Base with Pin 5 through Angular guide and Base
from the internal side. Secure them with Stop ring E-3. (Fig. 3)
(3) Fix M5x10 Thumb screw through Spring washer 5 and Flat washer 5
to Base and Angular guide. (Fig. 3)
(4) Assemble Base to the machine. (Fig. 2)
Spring washer 5
Depth guide
Pin 4
Pin 5
Stop ring E-3
Wrench 8
Loosen M5 (+) Pan head screw
while holding M5-8 Hex lock nut
with Wrench 8.
Angular Guide
1. Remove M5x10 Thumb screw,
Stop ring E-3
Spring washer 5 and Flat washer 5.
2. Disassemble the hinge portion by
Base
removing Stop ring E-3 and Pin 5.
Angular guide
Fig. 4
Depth guide
Stop ring E-3
M5-8
Hex lock nut
M5 (+) Pan head screw
Flat washer 5
Spring washer 5
M5x10 Thumb screw
Pin 4
Base
P 3/ 10