Makita CC300D Technical Information page 10

C
ircuit diagram (cont.)
Fig.D-3
1. Place DC motor in Motor housing (L). 2. Fix Lead wires with Line filter
Wire connecting
Motor housing (L)
portion of
Receptacle
red dot
marking
Fig.D-4
Wiring to Terminal
Connected Receptacles to Terminals as drawn below.
Receptacle
Terminal
Receptacle
Fig.D-6
Wiring in Handle (R)
Do not route Lead wires over these ribs.
Controller
Wiring in Motor housing set
(if used) in these Lead wire holders
by pushing them in the direction
of the arrows.
Line filter
(if used)
Connect Receptacles
with Lead wires
as drawn on the right.
3. Mount Motor housing (R)
to Motor housing (L).
Lead wire
(black)
Motor
Lead wire
housing (R)
(red)
Fig.D-5
Put Controller in Handle (R).
Controller
Handle (R)
Lead wire
(white)
Switch
Switch
Terminal
P 10/10
Motor housing (L)
Handle (R)
Receptacle
Lead wire
(red)