Remote Sensor; Description; Safety Information - Honeywell E3Point User Manual

Description

The E Point Remote Sensor provides continuous monitoring for one of
3
the following gases in ambient air: CO, H
gases. Connected to an E
E3Point Remote to provide dual protection (a second location or to detect
a different gas type).

Safety Information

Users of the E Point Remote Sensor should fully understand the
3
installation, operating and maintenance instructions, otherwise protection
provided by the monitor may be impaired. Read the following warnings
before using the monitor.
WARNING:
• Install according to local electrical regulations and codes.
• Installation should be performed by qualified personnel.
• Do not paint over the sensor screen.
• Ensure the sensor screen is free of dirt and debris.
• Ensure the sensor screen is not covered.
!
• Do not expose the monitor to electrical shock or continuous
mechanical shock.
• Do not expose the sensor to high pressure water spray.
• Do not use the monitor if it is damaged. Inspect the monitor before use.
Look for cracks, missing metals, or plastics. If the monitor is damaged,
contact Honeywell Analytics immediately.
• The warranty will be voided if the customer or any unauthorized service
personnel attempts to repair the monitor.
To change a sensor cartridge, disconnect all power to the device,
remove the back cover, and pull out the "smart sensor" cartridge and
press the replacement cartridge into place. Once the Smart Sensor
is firmly in place, replace the back cover and reconnect power. Use
caution when pressing the Smart Sensor into place to avoid bending
the pins.
See
Alarm Menu
E Point Gas Monitor Technical Manual
3

Remote Sensor

Point Standalone monitor can be used with an
3
for special instructions for changing sensor gas types.
S, O , NO , and combustible
2 2 2
Remote Sensor
31