Advertisement
C7110C1001A, C7110D1009A WALL MODULES – PRODUCT DATA
OCCUPANCY BYPASS BUTTON AND
AUXILIARY LED (C7110D1009A, ONLY)
NOTE: The functionality of the occupancy bypass button
and the corresponding behavior of the auxiliary LED
of the C7110D1009A are dependent upon the
programming of the connected controller. Please
refer to the controller's technical literature and/or
application.
Occupancy Bypass Button
Pressing the occupancy bypass button of the C7110D1009A
connects terminals 1 and 7 (with resultant effects depending
upon the programming of the connected controller).
COM
CO2 OUTPUT 0...10 V
24 VAC/DC
NTC 20kOhm
SETPOINT
LED INPUT
OCC. OUTPUT
Fig. 16. Occupancy bypass button
LED Behaviors and Meanings
Table 3. LED behaviors and their meanings
service
model
external LED
LED
1 flash / sec
Controller-
C+D
for 90 sec
dependent
2 flashes /
Controller-
C+D
sec for 10
dependent
sec
Controller-
D
Dark
dependent
Lit con-
Controller-
D
tinuously
dependent
C
Dark
Green
C
Dark
Yellow
Green / controller-
C+D
Flashing
dependent
Lit con-
Yellow / controller-
C+D
tinuously
dependent
C+D
--
Flashing green
C+D
--
Flashing yellow
EN0B-0735GE51 R0317
< 60 Ohm
modes
remarks
"Sensor Out-
put" (S.O.) +
Calibration
"Relay Out-
warm-up
put" (R.O.)
modes
Calibration
S.O. + R.O.
in progress
Calibration
S.O.
successful
Calibration
S.O.
failed
CO2 <
S.O.
1000 ppm
CO2 >
S.O.
1000 ppm
CO2 <
R.O.
threshold
CO2 >
R.O.
threshold
S.O. + R.O.
ABC ON
S.O. + R.O.
ABC OFF
Example LED Behaviors
Auxiliary LED Indicating Override
When the auxiliary LED of the C7110D1009A has been
configured to indicate an override, it can display various
different behaviors, e.g.:
▪
auxiliary LED dark = "no override"
▪
auxiliary LED lit = "override bypass"
▪
auxiliary LED flashing once per sec = "override
unoccupied"
▪
auxiliary LED flashing twice per sec = "override standby"
or "occupied"
▪
auxiliary LED flashing four times per sec = wall module
receiving wink commands from controller
Auxiliary LED Indicating Occupancy
When the auxiliary LED of the C7110D1009A has been
configured to indicate occupancy, it can display various
different behaviors, e.g.:
▪
auxiliary LED dark = "effective unoccupied"
▪
auxiliary LED lit = "effective occupied" or "bypass"
▪
auxiliary LED flashing once per sec = "effective standby"
▪
auxiliary LED flashing four times per sec = wall module
receiving wink commands from controller
8
Advertisement
