Table of Contents
Advertisement
Upgrading/Replacing CRUs
Installing a DCA
To install a DCA:
1. Put on ground wrist strap and connect to appropriate ground.
2. Grasp the DCA by the handle with one hand and support it underneath with
3. Slide the DCA into the DCA bay 1. Make sure you position DCA correctly; it
Figure 84: Installing the DCA
4. Install the four screws that secure the DCA to the chassis 2. Tighten firmly.
5. Make sure the power switch on the back of the DCA is off (the 0 is pressed),
6. On the power switch on the back of the DCA, press the 1 to power on the
124
the other hand.
Caution:
Avoid touching the exposed PCBA on the bottom of the DCA.
should slide smoothly.
2
2
then connect the power cord and SCSI cable.
SuperLoader.
1
1/16 Tape SuperLoader Reference Guide
Advertisement
Table of Contents
