Converting Voltage To 220V - Grizzly G1014Z Owner's Manual

Converting Voltage
to 220V
The voltage conversion MUST be performed by
an electrician or qualified service personnel.
The voltage conversion procedure consists of
rewiring the motor and installing the correct plug.
A wiring diagram for each machine is provided for
your reference in the back of this manual, begin-
ning on Page 52.
Items Needed
• Phillips Head Screwdriver #2 ...................... 1
• Electrical Tape ............................. As Needed
• Wire Cutters/Stripper ................................... 1
• NEMA 6-15 Plug .......................................... 1
To convert the machine to 220V operation:
1. DISCONNECT MACHINE FROM POWER!
2. Cut off the existing 5-15 plug.
3.
Open the motor junction box, then loosen two
wire nuts indicated in Figure 7.
Ground
Figure 7. Motor prewired for 110V.
-14-
4.
Use wire nuts to connect wires as indicated
in Figure 8. Twist wire nuts onto their respec-
tive wires and wrap them with electrical tape
so they will not come loose during operation.
Qty
5.
Close and secure motor junction box.
6.
Install 6-15 plug on power cord, according to
plug manufacturer's instructions.
— If plug manufacturer's instructions are not
Remove
These
Wire
Nuts
Connect Wires
with Wire Nuts
Ground
Figure 8. Motor rewired for 220V.
available, NEMA standard 6-15 plug wir-
ing is provided beginning on Page 52.
Model G1014Z/G1014ZX (Mfd. Since 08/22)