Replacing The Incom Connector - Sony HDC-900 Maintenance Manual

3-13. Replacing the INCOM Connector

1. Remove the outside panel. (Refer to Section 1-4 of the
Installation and Maintenance Manual.)
2. Disconnect the harness connectors from the connector
(INCOM1 and INCOM2) of MB-882 board.
3. Remove the two screws, and remove the INCOM
connector assembly.
CN32
(INCOM1)
MB-882 board
HDC-900/950 MM
CN31
(INCOM2)
Precision
P2.6 x 5
INCOM connector assembly
4. Remove the two screws, and remove the INCOM1
connector or INCOM2 connector.
INCOM1
connector
Precision
P2.6 x 5
Precision
P2.6 x 5
5. Install the new INCOM1 connector and INCOM2
connector in the reverse order of steps 1 to 4.
3-13. Replacing the INCOM Connector
Nuts
INCOM2
connector
3-17 (E)