3-7. Replacing the CCU Connector
n
Optical cables used in the unit are very fragile. So do not
bend or yank in handling. This causes a break in the cable.
1. Remove the outside panel. (Refer to Section 1-4 of the
Installation and Maintenance Manual.)
2. Remove the four screws, and remove the heat sink
assembly.
HDC-900/950 MM
3. Disconnect the optical cables (yellow), and disconnect
Heat sink assembly
4. Disconnect the harness connector from the connector
5. Remove the three screws, and remove the connector
B2.6 x 6
the connector (CCU) from the connector of the MB-
882 board.
Connector ( CCU )
of AC/DC converter.
(Refer to steps 1 to 6 of Section 3-3.)
box.
3-7. Replacing the CCU Connector
MB-882 board
Optical cables
(yellow)
K3 x 6
Connector box
3-11 (E)