Advertisement
FUNCTION BUTTONS
1. Ringer volume selection
Set the ringer volume switch to the desired position ( /
have the maximum ringer volume, move the ringer volume switch to
the
HI
position. To have a low ringer volume, move the ringer volume
switch to the
LO
position. If you would prefer the ringer not to disturb
you, move the ringer volume switch to the
2. Preparation dialing function
In the standby mode, pre-dial the telephone number you want to call
(you can check the number before dialing and use
delete the incorrect digit), then press
3. Speaker Function
To switch your call to speakerphone, press the
the handset in the cradle. To switch back, just pick up the handset. In
speaker state, you can make or answer calls.
4. Redial Function
Lift the handset or press the
to redial the last dialled number.
5. SET Button
In the standby mode, press the
SET
6. DEL Button
In the on-hook state, press the
DEL
when you set the code. In menu mode, use the button to exit from the
menu. When the LCD shows the CID number, press the button to
delete the record. If you hold the button for more than 3 seconds, all
the CID numbers will be deleted.
HI LO OFF
/
OFF
position.
DEL
button to
REDIAL
button to dial it out.
button and replace
button, then press the
REDIAL
button
button to enter the menu.
button to delete the incorrect digit
6
7. One-touch memory
You can store 3 telephone numbers in the one-touch memory.
a. Storing a number in the memory
). To
In on-hook state:
s
1. Press
repeatedly to select the outgoing number you desire or input the
telephone number manually.
2. Press the
3. Press the desired location button (
NOTE
: To update the number stored in the one-touch memory, just
repeat above steps to store a new number to replace the old one.
b. Dialling a number from the one-touch memory
Either in on-hook or off-hook state, you can press one of the memory
button (
M1 M3
8. Pause Function
This feature allows you to insert a temporary pause during dialling
sequence. For example, dialling an international number (e.g.: 011-
886-22-795-1234), some telephone company systems will not register
the entire number entry without a pause between the prefix numbers.
You may have to dial 011-
time for the phone number to register with the telephone company's
system and complete the call.
9. FLASH button
Press
FLASH
another call or to get another call from "Call Waiting" (a special
telephone service).
NOTE:
If you do not have any special telephone service, such as Call
Waiting, pressing
current conversation.
t
or
button to select the incoming number or
STORE IN
SET
button and the LCD shows
M1 M3
~
~
) to dial out the matching number.
PAUSE
, dial 886 -
PAUSE
button to terminate a call and institute a dialling tone for
FLASH
button during a call may disconnect your
7
OUT
button
.
) to store the number.
. This allows adequate
Advertisement
