Advertisement
SETTINGS
This unit has the following special settings:
code setting, Out of system code setting, Flash time setting, IP
number setting, Dial mode setting, Alert setting, LCD contrast
setting.
In the on-hook state, press
SET
the LCD shows
SET 1 DATE
.
NOTE
: After you enter the setting mode, you can press
button to select the desired menu or press
these settings in sequence as following steps:
l
Time & date setting
Press
date setting mode and the digits for year will flash, use
button to select the desired number, press
enter the next item. The setting sequence is YEAR--MONTH--DAY--
HOUR--MINUTE. (When the date has been set, the matching week day
will automatically show on the middle line). When the setting is
finished you can press
SET
button to confirm and enter the next setting
mode automatically. The LCD will show
l
Area code setting
In some countries, if you have to call somebody
living in your city area (phone district) you do not have to dial the
related area code. With this feature you can set up your area code in
order to avoid its dialing every time you call back somebody using a
number from incoming calls list.
When the LCD shows
SET 2 CODE
enter the area code setting, the LCD shows
s
code you set before. Press
or
Time & date setting, Area
button to enter the setting mode and
s
DEL
button to exit or do
SET
button again to enter the time &
s
SET
button to confirm and
SET 2 CODE
.
,
press
SET
button to confirm and
CODE - - - - -
or the area
t
button to set it. Press
SET
button to
8
1. If you would like to put your phone on the desktop, please install
the bracket as figure 1.
2. If you prefer to mount the phone on the wall, please remove the
bracket and do the following steps as figure 2.
a. Install the two self-tapping screws (not supplied) at a distance of
67mm from each other and located on a horizontal line.
b.
Slowly slide the unit down until it snaps into place.
t
or
t
or
Figure 1
WALL MOUNTING
Figure 2
5
MOUNTING
PINS
Advertisement
